钨t3电池更换 - ifixit.pdf

Tungsten T3 Battery Replacement Tungsten T3 Battery Replacement Replace the battery in your Tungsten T3. Written By : Whitney © iFixit — CC BY NC SA www.iFixit .com Page 1 of 7 Tungsten T3 Battery Replacement INTRODUCTION This guide will take you step by step through the process of replacing the battery in the Palm Tungsten T3. TOOLS: PARTS: Paper Clip (1) Tungsten T3 Replacement Battery (1) Phillips #00 Screwdriver (1) Spudger (1) © iFixit — CC BY NC SA www.iFixit .com Page 2 of 7 Tungsten T3 Battery Replacement Step 1 — Battery  Unscrew the two Phillips #00 screws on either side of the device, on the sliding handwriting panel. Step  Slide out the handwriting panel.  Insert a paper clip into the two marked small holes on the back and push downwards while pulling the handwriting panel gently .  You should see the buttons connector, like the third picture. © iFixit — CC BY NC SA www.iFixit .com Page 3 of 7 Tungsten T3 Battery Replacement Step 3  Gently remove the handwriting panel from the device.  Be careful its still connected by the button cable. Peel the cable from the device carefully with a spudger it is attached with a