蒂森mc2出(--)后的简单解决方法（Thyssen MC2 out (-) after the simple solution）.doc

蒂森mc2出(--)后的简单解决方法（Thyssen MC2 out (-) after the simple solution） Thyssen MC2 (-) simple solution after the There are a variety of reasons N, I can only briefly say my own views ~ if there is a wrong place, also hope to master a lot of pointing out! ThyssenKrupp Elevator (-) there are generally self protection function of the elevator itself, is generally the elevator maintenance is not in place due to emergence of adjustment (-). If you have a diagnosis, youd better look at 0100 of the fault codes first, so that it is easy to analyze and solve the problem, If there is no diagnosis, you can try the following method: Generally after (-) after the power failure can be restored, but this can not solve the problem completely. If the power supply fails to solve the problem, it should be checked as follows. That also can repair after the parallel operation?? It is also in the flat area If the first thing to consider all relevant leveling to brake door zone switch to ZS switch ~ ~ ~ contactor emergency stop loop hall car door lock and so on to should be in the flat floor area! If you can go to overhaul, the general problem in advance to open the door in this respect ~! Check the top of the car: ZS switches and related lines! And contactor and relay contact check! If you dont want to use the function of opening the door ahead of time, you can cancel the function of opening the door in advance. If you can not go, inspection should generally check: 1, the brake detection switch to Should be adjusted to the right place. If the check switch is in place, the probability of going out will be much smaller! Adjustment method: the computer room overhaul, the S805 switch is pressed (that is, the MC2 board on the far right of the red button, press it, then check the switch on the switch In the invalid state) and then began to adjust the detection switch to optimum adjustment method: in the elevator stop state, take a piece of the old ID card inserted into the first round there to swit