空压机安装注意事项的详细说明（Air compressor installation notes）.doc

空压机安装注意事项的详细说明（Air compressor installation notes） Air compressor installation notes 1. selection of installation sites The installation of air compressor installation site is the most neglected by the staff, often after the purchase of an empty compressor to find a place, piping immediately after use, there is no prior planning. Not so hasty, but the formation of a fault of the air compressor after the maintenance difficulties and adverse consequences of air quality, so the appropriate installation site is a prerequisite for the proper use of air compressor system. (1) choose a well lit wide place for space and lighting for operation, maintenance and repair. (2) choose low air humidity, less dust, fresh air and a well ventilated place, avoid water fog, mist, oil mist, dust and multi fiber environment. (3) GB500292003 according to code for design of compressed air station requirements, the compressed air station heating machine room temperature is not lower than 15 DEG C, non working time machine room temperature not lower than 5 DEG C. (4) when the cooling compressor suction unit or wind air inlet is arranged indoors, the indoor temperature should not exceed 40 DEG C. (5) if the factory environment is poor and dust is heavy, the pre filter equipment shall be installed to ensure the service life of the parts of the air compressor system. (6) when a single exhaust volume is equal to or greater than 20m3/min, and the total installed capacity is equal to or greater than 60 m3/min of the compressed air station, the lifting equipment shall be installed, and the lifting capacity shall be determined according to the heaviest components of the air compressor unit. (7) the reserved channel and maintenance space, in accordance with the GB500292003 compressed air station design specification requirements, between the air compressor and the wall of the channel width according to engine size is 0.8 ~ 1.5m distance. 2. matters needing attention in piping of compressed air pipeline