中公教育中2014下半年教资统考小学《教育教学知识与能力》真题.doc

中公教育命中2014下半年教资统考小学《教育教学知识与能力》真题 文章来源：安徽教师招考网 / 参考真题：14年下半年全国教师资格统考小学《教育教学知识与能力》考试真题 参照讲义：《2014年全国教师资格考试小学教育教学知识与能力讲义》 命中概况：真题总题量为27题；直接考点命中总题量为21题，主、客观题均囊括其中。 命中详情如下： the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface and internal cylinder surface height difference, compared with the original values confirm the location. Internal vertical and horizontal cylinder under state key insertion installat