教学大纲程造价控制.doc

《工程造价控制》教学大纲 一、课程基本信息 【课程编码【课程类别】专业基础课 【适用专业】建筑工程技术 【课程性质】必修课 【总 学 时】96 【学 分】6 【使用教材】《工程造价控制》，北京大学出版社，斯庆宋显锐主编 二、课程教学总目标要求 课程目的：本课程是工程造价专业的一门专业基础课，是工程造价领域对工程造价进行管理的基本理论课程，它的基本任务是通过系统地学习工程造价管理的主要必威体育精装版：全过《》主编出版社《Visual Basic 6.0入门与实例》黄世阳主编大连理工大学出版社《Visual Basic编程篇》 主编电子工业出版社 四川电子机械职业技术学院 教学大纲 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the thickness. Once the lifting cylinder measurement of surface an