水仙花养殖方法（Narcissus cultivation method）.doc

水仙花养殖方法（Narcissus cultivation method） The three: hydroponic culture method The water have to be before the old stems and roots stripped clean, and then put into the breeding daffodils pot, add water to the Narcissus head 1 cm bulbs, placed in the shade, the bulb grows roots into the sunshine at flowering. The water planted daffodils change the water every day, on the one hand, to prevent water pollution caused by deterioration of root rot. On the other hand, change the water every day, clean water the roots also grow pretty white. The carving In order to make the daffodil leaves growing colorful, beautiful, the flower carving processing. The specific approach is: The first appearance of narcissus bulb scales and scrape off the dry roots, then carved. When the first Narcissus carved buds growing, the bending potential as the sculptured surface, and then use a small knife on the plate at 2 cm away from the root of the bulb from left to right across a line gently, and then cut in each side of a vertical line, and then stripped layer horizontal and vertical lines within the scope of the scales, and to dig the between the bud scales, until pale yellow leaves and scapes naked, then curly leaves. Then the other processing on the scape, with a knife at the top of the scape bud below the daffodils, from top to bottom blowing a line or for scape from the top to the bottom of a few thorn needle, scape growth also occurred metamorphosis, also to the wound side bending. According to the requirements of different shapes of the daffodils and a scraping Xuan is also different. The Narcissus head sculpted in time into the water immersion wound down, to clear the wound secrete mucus, change the water every day, soak about 2 days -3 days, the mucus clean, can be removed and covered with cotton wool diplectanum (Gen Pan). And then carved up into the fire, Narcissus basin water aquaculture put in the shade. A daily water and keep the water clean, to be diplectanum grow long when about 1