u盘启动盘制作（U disk boot disk production）.doc

u盘启动盘制作（U disk boot disk production） U disk boot disk production: 1, U disk format: it is recommended to use more than 1G capacity of the U disk Because you need to copy the system and the U disk startup software, you need to have enough Enough space) first use Flashboot to format the U disk One of the two modes of USB-HDD or USB-ZIP, I choose is USB-ZIP this model, just this Malata notebook can be very good support. 2, U disk version WinPE: think of the pain of installing XP under DOS, So you are ready to start the XP system installation with the U disk version WinPE, and later The test is feasible. I downloaded the winpe disk version is old could, Inside, in addition to WinPE, there are a variety of commonly used tools, the file after decompression Just copy it into the formatted U disk. Windows XP system installation: 1, set the U disk to start: press the F2 key to enter the BIOS settings after the boot, In the Boot menu, open the third USB boot options, Select Enabled, save and exit the BIOS settings. 2, will be ready before the XP installation disk all copy into the U disk, Then insert the U disk and boot, directly into the U disk to start, The start menu, select Start micro WIN-PE (by winpe) After that, you entered the WinPE system. Copy the XP setup disk from the U disk into a small copy The partition outside the C zone, and mine is the two partition, that is, the copy in the D area, Then run the SETUP.EXE file of the installation disk folder directly Now familiar with the XP installation interface, in accordance with the prompt, step by step to complete it. I dont like using the GHOST installation disk online, Feel a step by step, the normal installation more stable, all installed after further GOHST backup, easy to use, after recovery. If you have the habit of using GHOST restore mode to install the systems friends, the mirror file will be copied directly The U disk and copied to the outside Ultrachrome C District, WinPE old could use Norton GHOST32 brings