传真机常见问题（Common problems with fax machines）.doc

传真机常见问题（Common problems with fax machines） Analysis of common problems in fax machine use [date] [2006-9-11] [236] [author] [source] First, when sending faxes, why does the manuscript often appear transmitted skew or even paper jam? When a manuscript in the process of transmission, transmission is not skew the manuscript was card problem, we should timely check the internal paper transmission fax machine part of the two roller shaft is loose, because once the two roller shaft loosening will not produce enough pressure on the paper, paper is prone to skew or even blocked, so that two roller shaft loose, should be immediately cleaned and adjusted two to two roller shaft, a roller shaft back to normal working condition; two roller shaft if the installation position is not parallel, will easily lead to problems above, so we must ensure that the two roller shaft position parallel to the original guide plate placed in position; right or not, but also affect the transmission of the manuscript. Therefore in the transmission of manuscript before, must correctly adjust the original position of the guide plate, to send the manuscript placed neatly on the guide plate; in addition to the above factors, the normal transmission of obstacle paper on a transmission path is easy to block the manuscript, resulting in cardboard or blockage, so once the paper jam when we have to remember to open the side panel of the fax machine to cover paper path on scraps of paper or other obstacles clean. Two. Why does fax machine send multiple pages every time? Each page is transmitted fault phenomenon a very common and very common, possible causes of this failure are various, such as transmission of metal sheets of paper transfer part once the deformation occurs, will produce this fault, so once found the transmission sheet metal deformation, it should be immediately adjusted or even replace a a new driving metal plate; if the fax machine cover is not properly cover the words, also easy to cause t