网站大量收购独家精品文档,联系QQ:2885784924

报废的硬盘也能这样修复(Scrap hard drives can also be repaired).doc

报废的硬盘也能这样修复(Scrap hard drives can also be repaired).doc

  1. 1、本文档共4页,可阅读全部内容。
  2. 2、有哪些信誉好的足球投注网站(book118)网站文档一经付费(服务费),不意味着购买了该文档的版权,仅供个人/单位学习、研究之用,不得用于商业用途,未经授权,严禁复制、发行、汇编、翻译或者网络传播等,侵权必究。
  3. 3、本站所有内容均由合作方或网友上传,本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺!文档内容仅供研究参考,付费前请自行鉴别。如您付费,意味着您自己接受本站规则且自行承担风险,本站不退款、不进行额外附加服务;查看《如何避免下载的几个坑》。如果您已付费下载过本站文档,您可以点击 这里二次下载
  4. 4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等,请点击“版权申诉”(推荐),也可以打举报电话:400-050-0827(电话支持时间:9:00-18:30)。
查看更多
报废的硬盘也能这样修复(Scrap hard drives can also be repaired)

报废的硬盘也能这样修复(Scrap hard drives can also be repaired) Scrap hard drives can also be repaired Many people will be scrapped when they fail to find a hard disk or error in BIOS. In fact, if after the boot, the hard disk in the self-test can hear disk rotation sound, it is estimated that the main motor and control circuit board is no fault, there is still room for redemption. It should be noted that the hard disk is a delicate device, very fragile, before the repair, you should first wash your hands, release the remaining static electricity of the human body, and then operate. Unable to find the disk For HDD Not Detected error of the hard disk, first check the outside of the hard disk data signal line interface or distortion of solder joint interface exists. After removing the above possibility, remove the back cover of the hard disk and expose the circuit control panel. Unscrew the retaining screws on the control panel and separate the control panel from the hard disk body. You can see the two rows of spring pieces of the hard disk body. A row of power supply as main motor, another row as head of hard disk, mechanical arm, drive coil, power supply, and data transmission interface between hard disk main body and circuit control board. For no special package of hard disk, you can often see the spring and control circuit board corresponding parts are dust. With absorbent cotton dipped in anhydrous alcohol, clean the parts of the deformation of the spring sheet, and remove the oxide layer, under normal circumstances can be restored to normal. If the above process is not valid, then the main body of the drive must be turned on. Choose a few dust environment, unscrew the hard disk of the front cover screw (some with glue). Remove the front cover of the hard disk and see the disk clearly. First, the digital multimeter is used to detect whether the drive coil of the head arm is broken or not. The normal resistance of the coil is about 20 ohms. Next, check if the line on the head

您可能关注的文档

文档评论(0)

f8r9t5c + 关注
实名认证
内容提供者

该用户很懒,什么也没介绍

版权声明书
用户编号:8000054077000003

1亿VIP精品文档

相关文档