施工员题（Builders question）.doc

施工员题（Builders question） Builders examination questions First, the multiple-choice question 1, concrete construction joints continue to be pouring concrete should be handled as follows (ABCD). A, construction joints should be chiseled, clean B, 10-15mm cement mortar shop first C, remove the mortar on the reinforcing steel bar, D, and strengthen the vibration at the construction joint 2, concrete column construction joints can stay (ABD) parts. A, base top B, beam bottom C, plate bottom 2 - 3cm D, plate top surface 3, below belong to the influence of rebar and concrete adhesion force size factor is (ABCD). A, water cement ratio B, steel reinforcement diameter C, protective layer factor D, steel anchorage length 4, the following on the concrete construction joints to leave the location, the correct is (ABD). A, beams higher than 1m shall not be poured with the slab at the same time The B and one-way plates can be left in any position parallel to the short edge C, concrete wall construction joints shall not remain at the junction of vertical and horizontal wall Construction of D and concrete plate seams should be construction and ladder joints corresponding to 5, the main factors affecting the strength of concrete are (ABCD). A, water cement ratio, B, curing condition C, cement mark D, construction method 6, the construction requirements of the formwork system are (AC). A, ensure the shape, size and position of the structural components are accurate, B, the template surface is smooth and smooth C, has enough strength, stiffness and stability of D, and the joint close without leakage 7, concrete and workability include (ABD) and so on. A, fluidity, B, cohesiveness, C, slump, D and water retention 8, the masonry wall left straight Cha approach is correct (ABC). A, must be in the vertical intervals of 500 mm diameter 6 B, configuration of steel tie bar ends shall be bent 90 degrees hook C, Rachel tendons shall be extended to connect a 500 mm D, each pull rib material is 10