10T-4000电液伺服折弯机详细参数.doc

电液伺服折弯机Electro-hydraulic Servo bending machine 一．主要参数Major parameter No 序号 Name and model No 名称型号 数值 value 单位 Unit WE67K-100T/4000 电液伺服折弯机 Electro-hydraulic Servo bending machine 1 公称力 Nominal capacity 1000 Kn 2 工作台长度Length of the working table 4000 Mm 3 立柱间距离 Distance between stand 3100 mm 4 喉口深度 Throat depth 320 mm 5 滑块行程 Slide stroke 120 mm 6 最大开启高度 Max open height 380 mm 8 驱进速度 migration velocity 110 mm/s 9 工作速度 Working speed 12 mm/s 10 返程速度 Back speed 110 mm/s 11 主电机功率 Main motor power 7.5 KW 12 三相工作电源 Three phase working power 380/ 50 V/ Hz 13 轴向柱塞泵 Axial plunger pump 压力stress 31.5 Mpa 流量flow 63 Ml/r 型号model 10MCY14-1B 14 油缸直径Oil cylinder diameter 170 Mm 15 X轴行程 X axis stroke 600 Mm 16 外形尺寸 Dimension 长度Length 4100 Mm 宽度 width 1800 mm 高度 Height 2400 mm 二、供货范围： Suply itmes: 1. 电液伺服折弯机一台(含标准模具一套) Electro-hydraulic Servo bending machine one set(including standard tooling one set) 2.DA65W数控系统一套（带数控专用吊臂） DA65W digital control system on set ( with digital control exclusive crane arm) 三．本机优势 Advantage 主机控制轴 Main engine control shaft ???1)??Y1、Y2轴为滑块行程控制轴，用来控制折弯角度。 在机床两端装有两个光栅尺(Y1-Y2)，它们用来测定滑块与工作台的确切位置；光栅尺与工作台相连接，这样立柱弹性变形不会影响滑块的定位。滑块位移数据立即反馈到数控系统，它便可以测算出输出伺服阀控制信号。 Y1,Y2 shaft is to control stroke of slider, and to control bending angle. The 2 ends of the machine are equipped with 2 grating ruler(Y1-Y2) to measure the exact position of slide and the table; the ruller are connected with the table, sothat elastic deformation of the stand would not effect the positioning of slide. The data of slider go back to control system immediately, and come out of output servo valve control signal. 2)?X轴为后挡料控制轴，用来控制折弯翻边尺寸。X轴是选用进口的伺服电机通过同步齿形带轮驱动滚珠丝杆运动。两挡料爪在运动中始终保持同步。传动平稳，精度高，噪声低。 X shaft is for back gauge to control bending turnup dimension. The theory is to drive ball screw via simultaneous gear belt which is run by imported servo motor. The 2 material carrier claw keep always synchroniztion in movment, the transmission are stable, pr