惠普Procurve以太网交换机配置指南-Version-1.0.docx

惠普ProCurve以太网交换机安装配置指南中国惠普有限公司安装规划中心 产品介绍ProCurve 6120系列交换机分为两种型号：6120G/XG6120XG产品名称的规则：以6120产品的G/XG为例，G和XG都指端口速率，其中G表示1Gb per second，XG表示10Gb per second；”/”以前的部分特指内部端口速率，”/”以后的部分特指外部端口速率。前面板及端口介绍：端口6120 G/XG6120 XG端口类型端口名称端口类型端口名称16x 1GbE Server NIC portsD1-D1616x 10GbE Server NIC ports1-161x 10GbE CX4C11x 10GbE CX4 or 1x 10GbE SFP+（最左侧）172x 10GbE XFP portsX1;X25x 10GbE SFP+ ports18;19;20;21;222x 1GbE SFP portsS1;S22x 10GbE SFP+ ports or S2S links（最右侧）23;244x 10/100/1000 RJ-45 ports1;2;3;4　　S2S linkI1　　Management PortOOBMManagement PortOOBM10GbE CX4—The CX4 interface requires the use of copper cabling, similar to the variety used in InfiniBand technology, and is designed to work up to a distance of 15?m. CX4 technology is an attractive solution because it has the lowest cost per port of all 10Gb interconnects, at the expense of range. CX4 has a bigger form factor than either SFP or SFP+. 10GbE XFP ports—These 10GbE ports support SR (multi-mode fiber, 300 m) and LR (single-mode fiber, 10 km) optic transceivers based on the XFP version of the small form factor pluggable specification. XFP transceivers have a smaller form factor compared to several standards (XENPAK, X2, XPAK) that preceded it. The XFP ports support Industry Standard Servers (ISS) optics only. 1GbE SFP ports—These 1GbE ports support SX (multi-mode fiber, 550 m) and LX (single-mode fiber, 10 km) optic transceivers based on the SFP version of the small form factor pluggable specification using an LC physical connector. These ports also support 1000BASE-T copper connections using an RJ-45 connector. The SFP ports support ISS and ProCurve optics.10/100/1000 RJ-45 ports—These ports support standard RJ-45 Ethernet cables and each port can operate at one of three autosensing speeds.5x 10GbE SFP+ ports—These five ports are dedicated10GbE SFP+ ports that support SR (multi-mode fiber, 300 m), LR (single-mode fiber, 10 km), and LRM (multi-mode fiber, 220 m) optic SFP+ transceivers.2x 10GbE SFP+ ports—Individuall