ABI Support Training - 岛津仪器培训资料.ppt

ABI Support Training Shimadzu Scientific Instruments Prominence Set-up and Configuration Feeding the MS ABI – Shimadzu Relationship Sales Agreement ABI can sell Shimadzu HPLC with ABI MS SSI sales fully compensated Demo Lab Support Toronto Demo lab projects with Dr. Sakuma Foster City and Framingham support Presentations Control of the Prominence HPLC There are 3 ways to interface and control a Shimadzu HPLC CBM-20A CBM-20A Lite SIL-HT (SCL-10Avp) Communications settings are the same for all three – sort of… Control of the Prominence HPLC Please communicate with your local Shimadzu reps to coordinate installations and training. The Shimadzu Engineer will have either already set-up the HPLC or, ideally, is there with you to assist in the installation. Shimadzu is your partner in this endeavor. Please use the resources available to you. Having said this, we all no that the world is not an ideal place and “stuff happens”… Setting Comms – SIL-HT(SCL-10Avp) From MENU Screen: Press 4 (system) Set RELAY 1 to start with arrow keys Press F3 (next) Set: CLASSvp to 5 or 6 Interface to RS-232C Baud Rate to 19200 Level to ENHANCED POWER CYCLE the unit to save settings ROM version 5.33 OR LATER is acceptable. Setting Comms CBM-20A (Lite) From the front panel of either a pump or autosampler where the CBM Lite is installed: Press VP key 4X to CALIBRATION Press FUNC Enter 00000 (five zeroes) followed by ENTER Press BACK Press ENTER Setting Comms CBM-20A (Lite) Press FUNC 2X and begin entering the following. After entering a value press enter, then FUNC to move to next parameter. INTERFACE: 1 for RS-232C 2 for Ethernet (PREFERRED) ETHERNET SPEED 0 for auto-detect Setting Comms CBM-20A (Lite) The following 4 settings should be set up by the Shimadzu engineer USE GATEWAY (only if connected to network) 0 for NO 1 for YES IP ADDRESS SUBNET MASK DEFAULT GATEWAY Important to you: TRS MODE 2 for ANALYST communication POWER CYCLE the unit Preferred to use Ethernet for Comms We ha