IEC60598-1与AS-NZS60598-1的偏差.doc

Clause Requirement – Test Result - Remark Verdict SPECIAL NATIONAL DIFFERENCE Australia SPECIAL NATIONAL CONDITIONS Variations to draft Ed.6 of IEC 60598.1:2003 for application in Australia and New Zealand -- 0.2 Add the following references AS/NZS 3000, Electrical installations (known as the Australian/New Zealand Wiring Rules) AS 3112, Approval and test specification?Plugs and socket-outlets AS/NZS 3131, Approval and test specification?Plugs and socket-outlets for use in installation wiring systems AS/NZS 4695.707, Fire hazard testing of electrotechnical products, Part 707: Methods of test for the determination of the flammability of solid electrical insulating materials when exposed to an igniting source AS/NZS 60598.2, Luminaires, Part 2: Particular requirements (all parts) AS/NZS 60695.2.10, Fire hazard testing, Part 2.10: Glowing/hot wire based test methods?glow-wire apparatus and common test procedure AS/NZS 61535.1(Int), Installation couplers, Part 1: General requirements Noted P 0.4.2 Add a new second paragraph: In Australia, the supply voltage is 230 V/400 V +10% - 6% and for testing according to this Standard, the rated voltage shall be 240 V/415 V. Rated voltage 240V~ P 1.2.41 Amend clause to read: Material which does not comply with the glow-wire test requirements of 13.3.2; and material which can be easily ignited by spark, flame or hot surface when in contact with atmospheric oxygen and which can sustain a fire or explosion. N 1.2.62 Add a NOTE after the clause: NOTE – Includes plug-in night lights (which are intended to provide a source of low level illuminance in areas not normally illuminated at night).Particular requirements for plug-in night lights is proposed to be covered in IEC 60598-2-12 in the future. N 2.2 Add the following after the NOTE to paragraph 5: NOTE - Class 0 luminaires are not allowed in Australia and New Zealand. Class II N 3.2.12 Delete the fifth paragraph and the Note and replace with the following: In Australia, lu