鞋类一般缺点ok.doc

Raw material 原材料 Color Variation 色 差 Material stained材料有污染 Incorrect number of holes per inch square 网布目数不对 Color variation of the same patch/roll同卷色差 Color variation of different patches/rolls不同批次有色差 Bottom color appear露底色 The skin peels off 脱层 Stretching direction not correct延伸方向不对 Elongation rate is too much材料延伸率太大 Yellowing 变黄 Color fading away褪色 Color migration 溢色 Too many blood vessel血筋太多 Too many scars 伤痕太多 Too long /short hairy毛太长/太短 Defects of surface 表面瑕疵 Get mildew发霉 Cracks of surface 表面有裂痕（龟裂） Thickness not meet the standard厚度不合标准 Not dyed through没透染 Incorrect size of the material大小规格不正确 Lace length inconsistence 鞋带长度不一 Lace tip broken/open鞋带包头裂开 The paint of the lace tip peel off鞋带包头掉漆 Metal eyelet surface not smooth眼扣有凸疤 Incorrect side of material lamination贴合材料贴错面 Leather brittle/breakable真皮太脆 Poor cement of hot melt热溶胶不粘 Velcro substandard魔术带不良 Aging test fail老化不过 Incorrect material emboss 皮料纹路不对 Foam yellowing 泡棉黄变 Uneven stitching 车线不顺 Flexing test failed耐挠不过 Gore too weak松紧带弹性不佳 Substandard Injection logo 射出LOGO不良 Too stiff太硬 Too soft 太软 Too narrow太窄 Too wide太宽 Too long太长 Too short太短 Too thin太薄 Too thick太厚 Cutting Procedure裁剪 Wrong material cutting 用错材料 Wrong cutting dies 用错裁刀型号 Wrong size用错码数 Wrong positioning of cutting dies排刀错误 Too many layers may result in different specification of components, cutting failure, slip of cutting dies, distortion or jam of perfs. 裁层过多会导致部件有大小、裁不断、滑刀、冲孔易变形、冲孔堵塞 Failing on pairing by sticking matching label 流水标配对错误 Cutting dies are not sharp enough裁刀不锋利 Cutting board becomes harsh due to long time of use裁板使用过久表面不平顺 Size label peel off after oven treatment 尺码标烘箱后有脱落现象 Incorrect size label 尺码标烫印错误 Improper screen printing 网印线印不准 Out sourcing 发外 Material burning 材料打火 Difficult to weld on material 不能热切 Off position 错位 Printing peel off 油印会掉 Poor Printing Ink油墨不良 Unclear printing 印刷不清晰 Unclear HF emboss/deboss 高周波(凸凹)不明显 Material stained after HF embossing/debossing 压高周波(凸凹)污染 Golden foil peel off 烫金脱落