WAAS测试设备配置文档.doc

WAAS测试设备配置文档 一、WCCP旁路配置设置： 初始参数记录 网络物理配置 You must set the port to which the WAE is connected to full duplex IP地址分配 Central Manager ：内网可路由的一个IP地址，不用单独一个网段，管理用。 总部WAE ：可连接单独路由器以太口，也可以用路由器内网以太网口的子接口，注意使用和内部不同的单独网段。 分支WAE ：可连接单独路由器以太口，也可以用路由器内网以太网口的子接口，注意使用和内部不同的单独网段。 配置WAAS Central Manager 通过Console口连接，使用Setup命令： Please choose an interface to configure from the following list: 1: GigabitEthernet 1/0 2: GigabitEthernet 2/0 Enter choice: Press the ESC key at any time to quit this session Enter choice: 1 Do you want to enable DHCP on this interface (y/n) [n]: n Do you want to apply the configurations (y/n) [y]:y 指定Central Manager的管理地址，例如0 分配主要接口（primary interface）为gigabitEthernet 1/0 , 指定device mode 为 central-manager ,保存配置，重启设备： waas-cm# configure terminal waas-cm(config)# waas-cm(config)# primary-interface gigabitEthernet 1/0 waas-cm(config)# device mode central-manager waas-cm(config)# exit waas-cm# copy run start waas-cm# reload Proceed with reload?[confirm] y Shutting down all services, will Reload requested by CLI@ttyS0. Restarting system. Username: admin Password: System Initialization Finished. 指定此设备作为primary WAAS Central Manager. waas-cm(config)# central-manager role primary 生成并初始化管理数据库 management database 并使能管理服务 waas-cm(config)# cms enable The following message appears: Generating new RPC certificate/key pair Restarting RPC services Creating database backup file emerg-debug-db-01-25-2006-15-31.dump Registering Wide Area Central Manager... Registration complete. Please preserve running configuration using copy running-config startup-config. Otherwise management service will not be started on reload and node will be shown offline in Wide Area Central Manager UI. management services enabled Save the configuration on this WAAS Central Manager. waas-cm(config)# exit waas-cm# copy run start 配置总部WAE You must set the port to which the WAE is connected to full duplex Console口连接，使用Setup命令，输入基本网络配置。 指定primary interface为 gigabitEthernet 1/0 并 指定device mode 为application-