E工业废水池酚醛玻璃钢防腐工程.doc

1、工程概况 1.1施工范围：工业废水池。 1.2技术要求： 在设备表面贴衬玻璃钢，采用三布五油技术，达到表面平整光滑。 1.3施工目的： 本工作使设备充分达到防腐蚀作用。 3、施工准备 主要施工机械配置表 Mobilization Plan of Main construction machines 序号 机具名 称 Name of Machine 型号规格 Specification 数量（台） Quantity 备注 Remark 1 电动砂轮机 Electric grinding machine 2 5 凿子 Chisel 8 7 钢丝刷 Wire brush 10把 9 板（毛）刷 Board (hair)brush 30把 10 滚桶刷 Roller brush 30把 11 批灰刀 Plaster knife 6把 12 刮板 Scraper blade 9个 13 漆膜测厚仪 Varnish film thickness gauge 1 4、劳动力计划安排 劳动力配置计划表 Personnel Arrangement 序号 No. 工 种 Type of Work 配备人员数量 Quantity 备 注 Remark 1 表面处理工Workers for surface treatment 6 2 贴衬工 Pasting workers 6 3 刷涂工 Brushing workers 8 合计 Total 20 1．设备清理 表面处理:主要采用电动砂轮机、钢丝刷、凿子对混凝土表面进行清理，使表面达到清洁、平整，并有比较均匀的粗糙面,然后按照配比调配底料，调配方法是环氧树脂加固化剂，比例为2:1，底料充分搅拌均匀熟化后，将底料涂刷在表面上。 补充:损坏表面的修复方法 用电动砂轮机把高低不平的表面切割平整，再用电动角磨机把表面打磨干净，用腻子粉把损坏的表面抹平，使表面完全平整。 2.玻璃钢衬施工Repairing method for air bubbles If there are air bubbles on the surface of FRP, first use the small knives to cut and remove the bubbles, then brush the sizing materials on the bubble spot, and finally use the roller brushes to make the surface flat. Repairing method for damages If there are damages on the surface of FRP, first cut the damaged parts with electric angle grinding machine, then clean it and brush the sizing materials and glass cloth, finally use the roller brushes to make the surface flat. Besides, the repaired area should be slightly larger than the removed one. Construction methods: 1. Equipment Cleaning Surface treatment: Electric grinding machines, wire brushes, chisels are mainly used to clean the concrete surface in order to make it smooth and to have a relatively uniform rough surface. 2. FRP Lining Construction Preparing rubber: Rubber can be used only after fully mixing the proportioned rubber lining and making it evenly maturating in strict accordance with product instructions. First paste the prepared rubber on the pasting position, and when the rubber is solidified, paste the first layer