电气盘柜及二次接线-英文翻译.doc

TECHNICAL SPECIFICATIONS FOR CONSTRUCTION OF PANEL, CABINET AND SECONDARY CIRCUIT Technical Specification of construction Installation Construction Condition The adopted material, component and equipment shall be all conform to design requirement, and the national standard equipment shall have normal nameplate and certificate of product quality. The design document and other technical documents are complete. Construction drawings have been jointly checked up, technique clarification and necessary technical training shall have been accomplished. The quality of building and structure relating to installation of panel, cabinet and secondary circuit shall conform to relevant national existing stipulations about Architecture Engineering Construction and Acceptance Code. In case there are special requirements for equipment and design, it shall also be met The roof and floor shall not have leakage after construction. Indoor floor work shall be completed. Embedded part and preformed hole shall conform to design, and the embedded part shall be firmly fastened. The decorative work that may damage the installed equipment or couldn’t be carried through after installation of equipment shall be completed. General Specification The label color of mimic bus on panel and cabinet shall meet the regulations of following table: Label Color of Mimic Bus Voltage (kV) Color AC 0.23 Dark gray AC 0.40 Yellow brown AC 3 Dark green AC 6 Dark blue AC 10 Deep red AC 13.8-20 Light green AC 35 Light yellow AC 60 Orange AC 110 Vermeil AC 154 Shamrock AC 220 Purple AC 330 White AC 500 Light yellow DC Brown DC 500 Dark purple Note: 1. Width of mimic bus is 6 - 12 mm. 2. Color of equipment shall be as same as the bus with same voltage. 3. This table is inapplicable to light current and graphic screen. After installation and adjustment, light current equipment shall be prevented from damage when doing insulated test of small wiring. The preformed hole and