内转子永磁同步电机仿真设计计算结果1-优化.docx

ADJUSTABLE-SPEED PERMANENT MAGNET SYNCHRONOUS MOTOR DESIGN File: Setup1.res GENERAL DATARated Output Power (kW):5.5Rated Voltage (V):380Number of Poles:8Frequency (Hz):33.3333Frictional Loss (W):66Windage Loss (W):80Rotor Position:InnerType of Circuit:Y3Type of Source:SineDomain:TimeOperating Temperature (C):75 STATOR DATA Number of Stator Slots:48Outer Diameter of Stator (mm): 260Inner Diameter of Stator (mm): 180Type of Stator Slot:2Dimension of Stator Slot hs0 (mm): 0.8 hs1 (mm): 0.59 hs2 (mm): 22.0439 bs0 (mm): 3.2 bs1 (mm): 6.11469 bs2 (mm): 9.00436Top Tooth Width (mm): 5.85092Bottom Tooth Width (mm): 5.85092Skew Width (Number of Slots):1Length of Stator Core (mm): 60Stacking Factor of Stator Core:0.99Type of Steel:DW465_50Slot Insulation Thickness (mm): 0.3Layer Insulation Thickness (mm): 0End Length Adjustment (mm): 0Number of Parallel Branches:1Number of Conductors per Slot:58Type of Coils:11Average Coil Pitch:5Number of Wires per Conductor:1Wire Diameter (mm): 1.45Wire Wrap Thickness (mm): 0Slot Area (mm^2):203.789Net Slot Area (mm^2):169.299Limited Slot Fill Factor (%):75Stator Slot Fill Factor (%):72.0293Coil Half-Turn Length (mm): 150.3Wire Resistivity (ohm.mm^2/m):0.0217 ROTOR DATAMinimum Air Gap (mm): 1.325Inner Diameter (mm): 102.35Length of Rotor (mm): 60Stacking Factor of Iron Core:0.95Type of Steel:DW360_50Polar Arc Radius (mm): 88.675Mechanical Pole Embrace:0.78Electrical Pole Embrace:0.779791Max. Thickness of Magnet (mm): 3.5Width of Magnet (mm): 53.2512Type of Magnet:NTP264HType of Rotor:1Magnetic Shaft:Yes PERMANENT MAGNET DATAResidual Flux Density (Tesla):1.08Coercive Force (kA/m):822.5Maximum Energy Density (kJ/m^3):222.075Relative Recoil Permeability:1.04494Demagnetized Flux Density (Tesla):0Recoil Residual Flux Density (Tesla):1.08Recoil Coercive Force (kA/m):822.5 MATERIAL CONSUMPTIONArmature Wire Density (kg/m^3): 8900Permanent Magnet Density (kg/m^3): 7550Armature Core Steel Density (kg/m^3): 7700Rotor Core Stee