人类头骨纸模图纸（三）SkullINST.pdf

THE HUMAN SKULL - ASSEMBLY INSTRUCTIONS - page 1. WHAT YOULL NEED: Scissors, an X-acto knife, Elmers glue, tape, and a ruler or other straightedge. (This model should be printed on heavy card stock) ASSEMBLY: Most of this model will be assembled with tape (although we’ll use glue for the eyes and nose). So when we say ‘connect’ in the following instructions, you should use tape. (continued on next page) THE HUMAN SKULL -ASSEMBLY INSTRUCTIONS- Page 2. Before cutting out any of the parts, locate the LEFT EYE and RIGHT EYE pieces on Page 1. Use the X-acto knife to remove the white area from inside each piece. Next, cut out the CENTER piece. There are seven fold lines on this piece, and they should all be folded DOWNWARD. They are only marked faintly on the model so refer to Figure 1 for their location. After making all seven folds, connect the two lowe panels as shown in Figure 2. Now cut out the LEFT EYE piece and the RIGHT EYE piece. Connect the inner edge of each piece to the CENTER piece as shown in Figure 3. If tape extends over the eye holes, use the X-acto knife to trim it away. Next, cut out the LEFT FOREHEAD and RIGHT FOREHEAD pieces. Connect them to the upper edges of the eye pieces as shown in Fig