外企模具检查清单-英文版Mold test checklist.docVIP

Mold test checklist (press the tab key to fill-in the different fields) General information Company name: Address: Contact person: Phone number: Fax number: E-mail address: Mold delivery date: Mold return date: Carrier: (Name phone n°) Test’s target Short description (part quality, cycle time to be achieved, clamp tonnage reduction, etc…): Process information Specification of the machine presently used with this mold: Actual cycle time: Required cycle time: Actual cooling time: Injection time: Hold time: Recovery time: Plasticizing rate (g/s): Moving side cooling water: T°: Flow: Bar: Stationary side cooling water: T°: Flow: Bar:  Mold information Mold maker: Mold type: Stack mold Standard mold (2 platens) If stack mold, please specify section dimension of the sprue bar: Mold mounting pattern: Clamps Euromap (screw) Minimum stroke for free drop: Mold size: Height (L): mm Width (B): mm Shutheight HR+HL: mm Weight: Kg Locating ring diameter: Moving platen: Stationary platen: Locating ring thickness: Moving platen: Stationary platen: Are both locating rings removable Yes NO Mold cooling information Quantity of cooling circuit: Moving platen: Stationary platen: Water fitting: DME Hasco Staubli Other Water fitting size:  Mold information Ejector information Is the machine ejector used: Yes No Ejector stroke required: How many ejectors rods will be used: (For example, 1 in the middle) Distance between moving plate ejector Rode connection surface into the mold = Maximum diameter possible = Fixation thread into the mold: - thread type = - male or female Cores information How many hydraulic core functions are needed: Stationary platen: Moving platen: Core pull sequence: Core limit switch socket Type and wiring information: What kind of hydraulic Connectors will be used: How many pneumatic core functions are needed: Stationary platen: Moving platen: Core pu