ansys orders 笔记.doc

分享一下！ BEGINNERS GUIDE TO ANSYS COMMANDS The symbol * corresponds to the following: * -- k, l, a, v, e, n, cm, et, mp, r where == k -- Keypoints l -- Lines a -- Area v -- Volumes e -- Elements n -- Nodes cm -- component et -- element type mp -- material property r -- real constant $ -- d, f, sf, bf, ic, where == d -- DOF constraint (ux... in Structural, Temp in thermal, f -- Force Load ( Heat in thermal) sf -- Surface load on nodes bf -- Body Force on Nodes ???? More Commands can be generated by sensible combinations of $* family of commands. See the following list of $* possible options ????? $* -- dk -- DOF constraints on KP (Vx,Vy,Pres... in CFD) dl -- DOF constraints on Lines da -- DOF constraints on Areas fk -- Force on Keypoints sfl -- Surface load on Lines sfa -- Surface load on Areas sfe -- Surface load on element faces bfk -- Body Force on Keypoints bfl -- Body Force on Lines bfa -- Body Force on Area bfv -- Body Force on Volumes bfe -- Body Force on Elements ic -- Initial Conditions , p -- If ,p was issued at the end of the Command(in Input Window) the GUI based picking menu will be activated. Useful for listing, plotting, meshing, deleting, etc.. ********************************************************** 1. Listing of picked Entities: COMMAND SYNTAX: *LIS,p $*LIS,p A few Combinations of this command are: klis,p -- List KP llis,p -- Lists Lines alis,p -- Lists Areas vlis,p -- Lists Volumes elis,p -- Lists Elements nlis,p -- Lists Nodes cmlis,p -- Lists components cslis,p -- Lists user created local co-ordinate systems dlis,p -- Lists DOF constraints specfied on nodes dalis,p -- Lists DOF constraints applied on Areas flis,p -- Lists force on Nodes sfllis,p -- Lists Surface Load on lines bfalis,p -- Lists body force load applied on Areas iclis,p -- Lists Initial condition on Nodes ??? If ,p was not issued, all entites currently selected will be listed. For certain commands ,p cannot be issued. Se