基于DEFORM-3D的压料油缸闭塞成形工艺可行性研究-精密成形工程.PDFVIP

第 8 卷 第 5 期 精 密 成 形 工 程 2016 年 09 月 JOURNAL OF NETSHAPE FORMING ENGINEERING 131 基于 DEFORM-3D 的压料油缸闭塞成形工艺可行性研究 叶星辉，郑光文，白凤梅，周二停 （ 安徽工业大学 冶金工程学院，安徽 马鞍山 243000 ） 摘要：目的 研究剪板机压料油缸缸体闭塞热精锻成形工艺的可行性。方法 制定闭塞热精锻成形工艺， 运用 DEFORM-3D 软件对缸体单元成形过程进行有限元模拟分析，得到了金属流动规律、金属流线、 挤压力载荷、合模力载荷随挤压行程变化的结果。结果 模拟结果表明，锻件金属流线分布合理，无明 显交叉、断裂情况，整个过程中挤压力与合模力载荷也维持在一个较低水平。对合模力大小进行了计 算，计算结果与模拟的误差为 8.4%，最后结合工艺进行了工业性试制。结论 成形后的锻件无飞边， 尺寸精度高，力学性能良好，无明显缺陷。 关键词：压料油缸；成形工艺；DEFORM-3D ；数值模拟 DOI ：10.3969/j.issn.1674-6457.2016.05.021 中图分类号：TG376 文献标识码：A 文章编号：1674-6457 (2016)05-0131-06 Feasibility Study on the Forming Technology of Press Cylinder Block Based on DEFORM-3D YE Xing-hui, ZHENG Guang-wen, BAI Feng-mei, ZHOU Er-ting (School of Metallurgical Engineering of Anhui University of Technology, Maanshan 243000, China) ABSTRACT: The work aims to study the feasibility of hot forging forming process of shear machine pressing cylinder block. Hot precision forging process of block was established. Finite element simulation analysis was carried out for the cylinder unit forming process by DEFORM-3D software. The results of the metal flow rule, metal flow line, extrusion force load and die load along with the change of extrusion stroke were obtained. The simulation results showed that the distribution of metal flow line was reasonable and there was no obvious cross or fracture. In the whole process, the extrusion force and the clamping force load were also maintained at a lower level. The size of mold closing force was calculated and the error of calculation result was