河北省某垃圾处理厂施工组织设计.docVIP

晶晶公司思前厂房的设计 何玉昌 ( 西南科技大学网络教育学院 建筑工程技术 09级春 ) 内容摘要：本工程为一门式钢结构厂房, 位于石家庄高新技术开发区。设备安装生产线为新建，设计中主要包括建筑设计、结构设计、PKPM设计三方面内容。 建筑设计主要是确定建筑的平面、立面、剖面,以及对承重和维护结构进行布置。 结构设计部分首先确定结构方案以及承重构件的选型。在此基础上完成厂房框架的内力分析及构件的设计，其内容包括门式刚架的内力计算和荷载组合,厂房柱的截面及节点设计,檩条设计,墙梁设计,吊车梁设计。 PKPM设计主要是对刚架进行计算，熟悉掌握PKPM系列软件的运用。同时，对手算及机算的结果进行比较。最终完成设计的全部内容。 关键词：钢结构 建筑设计 结构设计 Jingjing the company before the plants design thinking He Yuchang (Southwest University of Science Institute of Architectural Engineering Technology Network Education Spring 09) Abstract:This project is a typical workshop of gate-like steel structure, which lies on SHIJIAZHUANG development zone. the production-line of equipment-setup is new.The design mainly includes three factors: design of architecture; The design of architecture contains the construction the plane, the vertical surface, the section plane as well as the arrangement of load-bearing and structure-maintenance. The design of structure first determine the design of constructure and carrier shaping. On this basis, analyze the endogenic force and design members, which include: the calculation of the endogenic force of gate-like steel carrier, design of section and joint of column, roofing purlin design, wall beam design, crane beam design, Reinforced concrete foundation design and platform design. Designs based on the software of PKPM is mainly about the calculation of Steel frame; Then master the PKPM series software familiarly ;At the same time ,compare the result which is calculated by hand with the complete result; Finally finish all the contents of this design. Key word: Steel structure Design of architecture Design of structure 目 录 中文内容摘要/关键词………………………………………………………………1 英文内容摘要/关键词 ………………………………………………………………2 引言……………………………………………………………………………………4 一、建筑设计说明……………………………………………………………………5 （一）工业建筑的特点及设计要求……………………………………………5 （二）平面设计…………………………………………………………………6 （三）剖面设计…………………………………………………………………7 （四）单层厂房定位轴线的标定……………………………………………11 （五）立面设计………………………………………………………………11 （六