Part 5 - Master Slave SACST 培训教材.pdfVIP

Part 5 - Master Slave Joint Couplings Preparation 1) Under “Training Project”, create “MasterSlave” subdirectory 2) Copy SACINP.DAT model file, SEAINP.DAT seastate file and PSIINP.DAT soil data from “Static PSI” directory to “MasterSlave” directory. Modify model to add a flare boom Using “Member” “Divide” “Length” to break member 701L-705L at 4.0 m to add a new joint 7017. Add joint F001 at the same coordinate as joint 801L, joint F002 at the same coordinate as joint 7001 and joint F003 at the same coordinate as 7017. These three joints will be the support joint of the flare boom. Using “Joint” “Add” “Relative”, add joint F004 relative to joint F001, dX = -1.0 m Add joint F005 relative to joint F004, dX = -19.0 m and dZ = 10.0 m. Add joint F006 relative to F005 using dX = -1.5 m. Add joint F007 relative to F005 using dY = -0.75 and dZ = -1.5 m. Add joint F008 relative to F005 using dY = 0.75 and dZ = -1.5 m. Add member VT1 connecting F006 to F005, F005 to F004 and F004 to F001, add members VB1 connecting F006 to F007, F007 to F002, F006 to F008 and F008 to F003. Using “Member” “Divide” “YZ Plane”, and divide member F007-F002 with new joint F009 and F008-F003 with new joint F00A corresponding to X coordinates, -8.50 m. Using “Member” “Divide” “YZ Plane”, and divide member F005-F004, F007-F009 and F008-F00A corresponding to X coordinates, -13.25, -18.00, -22.75 and -25.75 m. Add framing members to the flare boom using member group VD1, VD2, VD3, VD4, VD5, VD6, VD7 and VD8 Add member properties for flare boom: Member group VT1, Diameter = 40.64 cm, Wall Thichness = 1.27 cm Member group VB1, Diameter = 32.385 cm, Wall Thichness = 0.953 cm Master Slave Joint