Part+A+Preliminary+-+Question AI考试试卷.pdfVIP

BV China IF AI PREQUALIFICATION TEST Part A: Preliminary 20 Questions 1 hour 9:00 AM to 10:00 AM (Show applicable Code paragraph references used to support your answer.)!!! Sample 1: When reviewing a material test report for plate materials SA-516 Gr70, What of the following must be included on the report. REFERENCE: Section II, Part A, SA-20, Answer : 5 1) Manufacturer’s name or trademark. 2) Chemistry of the material. 3) Physical properties of the material. 4) The heat and slab number forn which the plate was made. 5) Specification and Grade ,type or class. 6) Heat treatment time and temperature. Sample 2: If there is specific reason to question the procedure or the ability of personnel to perform nondestructive examination and ob tain the required results ,the Authorized Inspector may require . REFERENCE: Section V, Article 1 Answer : Re-qualification Page 1 of 6 Question 1 What of the ASME Code symbol stamps are prescribed for use with either I or Section VIII ,Division 1 ? REFERENCE : Answer: Question2 The official Code symbol you would expect to see on each of the following would be : a) Cast iron boiler 30 psi MAWP b) Hot water boiler ,180 psi MWP REFERENCE: Answer: Question 3 Corrective action relative to nonconforming materials (including fabrication errors) after release of incoming material for fabrication, is subject to review and acceptance by whom ? REFERENCE: Answer: Question 4 What is the maximum carbon content of steel to be used in welded construction or to be shaped by thermal cutting process? REFERENCE: Answer: Page 2 of 6 Question 5 The inspector may request w