基于PRO-E嵌件型塑胶模具设计毕业论文1.doc

CHANGSHA UNIVERSITY OF SCIENCE TECHNOLOGY 毕业设计（论文） 题目： 基于PRO-E嵌件型塑胶 学生姓名： 李 明 勇 学 号： 911009103978 班 级: 专 业： 指导教师： 2010 年 9 月 题目 基于PRO-E嵌件型塑胶学生姓名： 李 明 勇 学 号： 911009103978 班 级： 所在院(系): 指导教师： 完成日期: 2010.9 基于PRO-E嵌件型塑胶  BASED ON PRO-E PLASTIC MOLD OF INSERT-TYPE ABSTRCT This design is mainly for plastic mold of insert-type. Through the analysis of plastic parts for process, and design a injection mold finally. This design from the structure and process of the parts, and the specific structure of the mold, to design specification like the casting system of the mold、die forming part of the structure、the roof system、cooling system、the choice of injection molding machine and parameters of the test. The main task is to design a type of plastic mold of insert-type, make the mold can reach the requirements of plastic parts processing, and realize the automation production to increase output. According to the specific structure of parts, we can known that this is a injection mold of the side gate and the single sub-surface. Key words ： Injection mold; Process; Desig目 录 第1章 绪论...................................................................... 1 第2章 零件分析与总体设计.......................................................3 2.1零件分析....................................................................3 2.2总体设计....................................................................3 第3章 模具设计..................................................................8 3.1 应用软件概述..............................................................8 3.2 工件尺寸的计算............................................................9 3.3 内模镶件排位..............................................................12 3.4 Pro/ENGINEER模型造型....................................................13 3.5 注射机的选择.............................................................15 第4章 成型零部件工作尺寸计算.................................................26 4.1型 腔、型工作尺寸的计算.........