[其它考试]Autodesk Moldflow Insight BronzeA Certification.pdf

Autodesk Moldflow Insight Bronze Certification  Introduction  Section 1  Section 1 has questions that relate to the use of Synergy, using various Autodesk Moldflow Insight flow analyses and results interpretation.  Ensure you have the answer sheet which is an excel file called BronzeA_Answers.xlsx.  Place your answers on the Sect1_Answers sheet.  For each question, choose the BEST answer.  Each question is worth 1 point for a total of 70 points.  No reference materials may be used during this portion of the exam.  Plan on section one taking 40-50 minutes to complete. You may have as much time as you like, but don’t take too much time, you will need it to complete section 2.  Append your name to the beginning of the answer sheet file name, such as John_Doe_BronzeA_Answers.xlsx . Section 2  Section 2 is a hands-on.  You are given 5 study files to compare the results.  You are given a study file and directions for creating a feed system.  You are given several MFR files to interpret molding window and Fill + Pack analysis results.  This section is worth 205 points in total.  For this section you can use the on-line help as a reference. Grading  There are a total of 275 possible points in this exam. To pass this test, you must score an 80% or 220 points minimum. Return the necessary files to Autodesk for grading. Instructions for returning the files are on page 34.  The entire test should take between 5 to 6 hours to complete. The test is limited to 6 hours. Autodesk Moldflow Certification Exam, Bronze A 1 of 34 Revised 7/6/10 Section 1  1. In general, the largest component of the cycle time is: A. Fill time. B. Pack time. C. Cooling time. D. Clamp open time. 2. Due to fountain flow, the highest velocity in the cross section is located at the: A. Center of the cross section. B. Plastic/metal interface also called the mold surface. C. Half way between the