6MT装配工艺英文版.pptVIP

Main line assembly process-method 1 To assemble differential assembly To assemble shafts system (contain input shaft asm ,two lay shafts asm, bearing plate and oil catcher) Main line assembly process-method 1 To assemble 1/2/5/6 fork and rail into clutch housing, pressure pin into ? for and rail To assemble reverse idler asm into clutch housing Main line assembly process-method 1 To fasten bolt to connect reverse shaft with clutch housing To pressure bush into reverse shaft Main line assembly process-method 1 To fasten two bolts to connect the side of reverse shaft with clutch housing To assemble rail and ? fork, reverse fork, and pressure pin into reverse fork and rail Main line assembly process-method 2 To assemble reverse idler asm into clutch housing To fasten bolt to connect reverse shaft bottom with clutch housing To pressure bush into reverse shaft Main line assembly process-method 2 To fasten two bolts to connect the side of reverse shaft with clutch housing To assemble magnet into clutch housing To assemble shafts system (contain input shaft and two lay shaft asm, oil catcher, bearing plate, 1/2/5/6 forks asm and 3/4/R forks Asm) Main line assembly process To dynamically measure the space of differential bearing, and choose proper shim to put into housing, then to pressure differential bearing outer race Main line assembly process To dynamically measure the space of differential bearing, and choose proper shim to put into main case, then to pressure differential bearing outer race into main case Main line assembly process To assemble two tools (long bolts) for direction To assemble magnet in method I To gelatinize on main case Main line assembly process To assemble main case assembly To move the two long bolts, put 4 seal washer and fasten 4 bolts to tighten bearing plate To fasten above 9 bolts to connect main case with clutch housing Main line assembly process To rotate 180°and fasten 11 bolts To assemble drain plug To rotate 180°and assemble rail and