3310磁盘更换.docx

SUN-3000磁盘更换. Examine the back of the RAID array and any attached expansion units, and record the cable connections. 2. Prepare the RAID product for the disk replacement: a. From the RAID firmware Main Menu, choose view and edit Configuration parameters, then choose Drive-side Parameters. b. Set the Periodic Drive Check Time option to 5 seconds. 3. Find the Channel number and target ID combination (for instance, Chl 0 ID 4) of the disk drive to be replaced: a. From the RAID firmware Main Menu, choose view and edit Drives. b. Locate the disk drive that has a status of BAD or FAILED in the Status columna. On the RAID firmware Main Menu, choose view and edit Drives and press Return. b. Select the drive you want to identify and press Return. c. Choose the Identifying scsi drive function. d. Choose flash all But selected drive to flash the activity LEDs of all of the drives in the drive channel except the selected drive, and press Return. Scanning the New DriveAfter you have replaced a disk drive, perform the following steps. 1. From the RAID firmware Main Menu, choose view and edit Drives. 2. Check the status of the disk drive. The status field will specify NEW_DRV or USED_DRV until it is assigned as a GLOBAL or LOCAL spare with STAND-BY status. 3. Scan the replaced disk drive into the configuration with the following steps: a. From the RAID firmware Main Menu, choose view and edit Drives. Select any disk drive in the list and press Return. b. Choose Scan scsi drive and press Return. Select the Channel number, then the ID number of the replaced disk drive, and confirm Yes when prompted. c. Verify that the message Scanned SCSI drive successfully is displayed. 4. From the RAID firmware Main Menu, choose view and edit Logical drives and use the following table to continue.If the target logical drive status is GOOD, the spare disk has successfully protected it and is now integrated into the logical drive, and the replacement disk drive is available to be assigned. Assigni