铆螺母在汽车音响安装上的使用.pdfVIP

BMW Z3 Model 68 Subwoofer Installation Instructions BMW Z3 Model 68 Installation Instructions IMPORTANT: Read these instructions from start to finish twice before you even go near the car! Professional installation is recommended for those who are unfamiliar with car audio. These instructions assume you have already installed your new amplifier. What’s Included: 1. The Model 68 enclosure cabinet 2. 6” x 8” neodymium subwoofer 3. Foil-backed damping sheet 4. Gold-plated wire terminal cup 5. 1/16” grey self-adhesive gasket foam (26”) 6. 1/ ” black self-adhesive gasket foam (30”) 4 7. 1/ ” x 4.5” hex bolt 4 8. 1/ ” x 1” hex bolt 4 9. 1/ ” flat washer 4 10. Rivet nut 11. Rivet nut installation wrench 12. (4) #8 x ¾” phillips pan-head screws 13. (4) #8 x 1/ ”phillips screws 2 14. 14 AWG speaker wire (18”) 15. (4) 1/ ” wire terminals 4 What You Will Need: 1. Power drill 2. 1/16” and 7/16” drill bits 3. Philips screwdriver 4. 7/16” socket driver or wrench 5. Stiff-blade putty knife or similar flat bladed tool 6. Utility knife, diagonal flush cutters, or small hacksaw 7. Center punch or marking pencil 8. Wire strippers/crimpers Remove the old enclosure 1. Carefully remove the subwoofer enclosure cover by first lifting the rear edge of the cover and then lifting entire cover straight up. The cover should lift out with minimal effort, but may require some additional effort to release the rear snaps. Take your time and be careful when removing the sub lid! The easiest thing to do is to insert a flat, metal, handled-tool like a stiff putty knife and carefully pry each side up from the back. NOTE: If you have the storage compartment, you may find it easier to temporarily remove the storage compartment lid while performing the inst