Fuzzy Logic Speed Controllers Using FPGA Technique ….ppt

POWER ELECTRONICS Instructor: Eng. Jalal Al Roumy The Islamic University of Gaza Faculty of Engineering Electrical Engineering Department ??? ???? ?????? ?????? EELE 5450 — Summer 2012 Lecture 8 Chapter Three Series and Parallel operation of SCRs In high voltage and high current applications, Power diodes have to be connected in series and parallel. Similarly, for high voltage and high current applications, SCRs also have to be connected in series and parallel. Chapter Three Series operation of SCRs If the input voltage is higher than the voltage rating of the available SCR, two or more SCRs must be connected in series. Chapter Three Series operation of SCRs Due to the production spread, the characteristics are not identical. The forward Breakover voltages (VBO) are not the same. In the reverse region and in the forward blocking region ,there is a different in the voltages due to the same current in these two regions. The two Scrs will not equally sharing Es=1000v. At any further increase in voltage ,Vbo2 on Scr2 would be exceeded, and this Scr would break over in the forward direction. Under steady state condition ,external resistor (R) have to be connected across each SCR. And here the SCR currents will differs and hence the new characteristics will appears. Chapter Three Series operation of SCRs The forward and reverse leakage current through the SCR varies due to the production spread. Ibmin and Ibmax is worst case (? Ib= Ibmax – Ibmin) (? Ib= Ibmax – Ibmin) Emax is the maximum voltage across Scr1 We have I1I2 Emax= I1R For more than two Scrs we will assume that the other current are equally, so. Es=Emax+(ns-1)*R*I2 I2=I1-?Ib R=(2Emax-Es)/?Ib Ibmax is only available in the datasheet , so The worst case is Ibmin=0. R=(2Emax-Es)/Ibmax (R for sharing voltages on SCR) (R must be large to decrease power losses R=(2Emax-Es)/Ibmax The transient sharing of voltages is accomplished by connecting capacitor across each SCR. Th