pDIVE MX-ECO系列变频器英文说明书.doc

pDRIVE Operating instructions Modbus pDRIVE MX eco 4V pDRIVE MX pro 4V pDRIVE MX pro 6V pDRIVE MX multi-eco pDRIVE MX multi-pro Modbus General remarks The following symbols should assist you in handling the instructions: Advice, tip ! General information, note exactly ! The requirements for successful commissioning are correct selection of the device, proper planning and installation. If you have any further questions, please contact the supplier of the device. Capacitor discharge ! Before performing any work on or in the device, disconnect it from the mains and wait at least 15 minutes until the capacitors have been fully discharged to ensure that there is no voltage on the device. Automatic restart ! With certain parameter settings it may happen that the frequency inverter restarts automatically when the mains supply returns after a power failure. Make sure that in this case neither persons nor equipment is in danger. Commissioning and service ! Work on or in the device must be done only by duly qualified staff and in full compliance with the appropriate instructions and pertinent regulations. In case of a fault contacts which are normally potential-free and/or PCBs may carry dangerous voltages. To avoid any risk to humans, obey the regulations concerning Work on Live Equipment explicitly. Terms of delivery The latest edition General Terms of Delivery of the Austrian Electrical and Electronics Industry Association form the basis of our deliveries and services. Specifications in this instructions We are always anxious to improve our products and adapt them to the latest state of the art. Therefore, we reserve the right to modify the specifications given in this instructions at any time, particular those referring to measures and dimensions. All planning recommendations and connection examples are non-binding suggestions for which we cannot assume liability, particularly because the regulations to be complied depend on the type and place of installation and on the