明电舍(MEIDEN)VT210S系列变频器英文说明书.doc

MEIDEN AC SPEED CONTROL EQUIPMENT THYFREC-VT210S 400V System 37 to 315kW (C/T) 400V System 45 to 370kW (V/T) QUICK START GUIDE ———————— NOTICE ———————— 1. Read this manual thoroughly before using the VT210S, and store in a safe place for reference. 2. Make sure that this manual is delivered to the final user. MEIDENSHA CORPORATION QS210S Rev1 i Feb 2000 Quick Start Guide Meiden Europe Ltd Warning This Quick Start Instruction Guide is intended as a guide only. Read the Instruction Manual thoroughly before using the VT210S. Use extreme caution during installation. Do not open the front cover while power is applied. Always ground the Inverter heatsink. If in doubt, refer to your supplier or MEIDEN DRIVELINE Tel: 01908 276000 The information contained in this publication, including numerical data, has been prepared as a general guide to the product. No responsibility is assumed for errors herein. Meiden Europe Ltd reserve the right to make changes to this document and Instruction Manual at any time. EOE QS210S Rev 1 Page 1 Quick Start Guide Installation Install the Inverter vertically, so that the cable glands face downwards. Allow for the correct spacing around the Inverter for ventilation (X +50mm, Y +200mm). Fig. 1. Always ensure that the Inverter is switched off before wiring. Meiden Europe Ltd Please note that TBA must be set in position shown (Fig. 2.) for 380-400V operation, and in position 1-2 for 415-460V operation. Connect wiring as shown in Fig. 2. Make sure that correct short circuit protection devices are fitted and best wiring practises are observed (see 3 in the supplied manual). A Ferrite is supplied with the filter, which must be fitted to meet EMC compliance. The motor phase cables must be inserted through the output ferrite as per EMC Filter Kits— Guide to Installation and Use. Fig.2. Voltage Surge N.B. Terminal/Busbar arrangements differ on larger drives. (Refer to 8 in the supplied manual). For long motor cable lengths (30m), a motor choke can