【必威体育精装版资料】塑胶模具加工合同(中英文版本)免费下载.docx

Contract No. : 合同号： Page/页数:  PAGE 45/ NUMPAGES 45 PURCHASE CONTRACT of Plastic Mold 塑胶模具加工中英文版本采购合同 BETWEEN The Buyer（Party A）: THE BUYER Address:地址： Postcode邮编： Contacts联系人： Tel电话： Fax传真： AND The Seller (Party B)： 加工卖方（乙方)： Address:东莞市昱卓精密塑胶模具厂 地址： Postcode邮编： Contacts联系人： Tel电话： Fax传真： Signing Place: 签约地点：东莞市大岭山镇大岭村纵队路93号 Signing Date: ___________________ 签约日期: After friendly negotiation, Party A and Party B agree to reach this contract as follows for complying with. 甲乙双方经友好协商，甲方和乙方一致同意签订以下合同，以便共同遵守。 Object:合同标的物： 序号/No产品编号/Part No注塑产品规格/plastic parts spec模具数量/Quantity of molds模穴数/Mold Cavity模具含17%税价格（元)/Tooling cost with 17% vat(RMB)12345Total 乙方根据甲方提供的注塑产品要求负责设计制造模具. 上述模具单价为人民币含17%税, 包括了模具设计,生产,试模,以及产品在甲方验收合格前的所有相关费用. Party B should design and produce the Molds. The unit price for the molds mentioned above based on RMB(included 17% vat), which includes the design, produce ,trial run cost and any other cost about the Molds before the plastics sample have been approved by Party A. 2. Quality Standard: the quality of goods shall accord with the standard as follows: 质量标准：本合同标的物需符合以下质量标准：（可以多选） According with state standard and industry standard ，if they are not the same, the higher shall prevail 符合国家标准和行业标准，若两者不一致以高者为准 It must be at least 500,000pcs good plastic parts which can be produced by the mold in the contract 合同中的模具必须可以生产至少50万模次的合格产品 The plastic products which are produced by the Molds need to meet the requirement of Party A, refer to Appendix1 standard of plastic products. 该模具生产???注塑产品应符合甲方的要求，详见附件1注塑产品标准。 3． Lease Maintain 所有权,租借以及维护保管 3.1 The property of molds will transfer to Party A after inspection and acceptance. Party A will decide to lease the Molds to Party B , then Party B shall use them to produce plastic parts in their own factory. In period of lease term, the damage and destroy risk of molds is borne by Party B , Party B should keep the mold