9700校准手册.doc

Form 4229T, 01-99Supersedes Form 4229T, 08-97 CALIBRATION INSTRUCTIONS FORGSP 9700 VIBRATION CONTROL SYSTEM Calibration Procedures The Calibration primary screen can be selected by pressing Calibrate from the Logo screen. The Calibration Procedures primary screen contains a list box of calibration procedures. As the procedures are individually highlighted by selecting or , the equipment components to be calibrated for each procedure are shown in yellow on the illustrated GSP 9700 Vibration Control System. Begin calibration procedures by selecting Begin Procedure. When finished calibrating, select Exit. Throughout the calibration procedures Back Up can be selected to return to the previous step. NOTE: The calibration weight used for calibrating the balancer and the inner dataset arm is stored in the console support just above the left rear weight tray pocket. Dataset arm and load roller calibrations require the optional calibration tool, 221-602-1. Servo-Stop? The calibration of the Servo-Stop? measures and stores characteristics of the motor drive and line conditions to allow accurate operation of the automatic wheel-positioning feature and proper speed control. To calibrate the Servo-Stop: Mount a wheel assembly of average weight onto the GSP 9700 Vibration Control System. Lower the hood and press the green START button. Wait for the motor to rotate the assembly at a very low speed. The motor will reverse directions twice. Servo-Stop calibration is complete. Balancer (3 Spin Procedure) Select Calibrate from the Logo screen. Select Balancer from the Calibration Procedures primary screen. Select Begin Procedure. Spin 1:Lift hood and install calibration weight on the left side of the faceplate in either hole by threading the calibration weight clockwise into the hole. Lower hood and press the green START button. Spin 2: Lift hood and remove calibration weight and install in the opposite hole on the same side of the faceplate by threading cali