镗床PLC智能控制系统设计 毕业论文（盐城工学院）.docVIP

毕业设计说明书 镗床PLC智能控制系统设计 专业 自动化 学生姓名 董跃 班级 B自动化081 学号 0810603115 指导教师 张胜超 完成日期 2012年5月日 镗床PLC智能控制系统设计 摘 要：镗床是一种精密加工车床，主要用于加工工件上的精密圆柱孔。这些孔的轴心线往往要求严格地平行或垂直，相互间的距离也要求很准确。镗床本身刚性好，其可动部分在导轨上的活动间隙很小，有附加支撑镗床能完成镗孔工序外，还可以进行镗、钻、扩、绞、车及铣等工序，因此，镗床的加工范围很广介绍T68型卧式镗床的结构和工作原理，分析镗床继电器控制系统。对系统的输入、输出点进行统计，根据PLC的选型相关规定和输入输出的总点数，选用日本三菱公司生产的FX2N-48MR可编程序控制器分配PLC的I/O地址，设计PLC的外接线图。采用逻辑代数设计法设计T68镗床PLC控制系统的程序，并通过 GX Simulator6-C软件进行程序仿真。在此基础上，针对系统调试、安装以及运行过程中出现的问题，进行分析，提出解决办法和注意的事项。最后从硬件和软件两个方面采取措施，提高了PLC控制系统的抗干扰能力。PLC控制系统取代原来的T68镗床继电接触控制系统使控制变得简单灵活，性能提高，并增强了其自诊断功能，维修也更加方便。 关键词：可编程控制器；镗床； Design of PLC Intelligent Control system of Boring Machine Abstract: Boring machine is a kind of precision lathe processing, mainly for processing the precision cylindrical bore in the workpiece. The axes of these holes are often asked to be strictly parallel or vertical, the distance between each of them also requires very accurate. Boring machine itself has good rigidity, the activity space of movable part on the rail is small, and has the additional support. In addition to finish boring process, boring machine can also be used for boring, drilling, expansion, twisted, cars and milling processes, therefore, the processing with a wide range of boring machine. Introducing the structure and working principle of T68 type horizontal boring machine, and anglicizing relay control system of boring machine. Designing overall reformation scheme based on PLC. To gather statistics input and output points on the system. According to the PLC selection rules and input and output of the total points, select Japanese Mitsubishi Co production of the FX2N-48MR PLC. To allocate the PLC I/O address, and to design PLC external wiring diagram. Using algebra of logic design method to design the PLC control system program of T68 boring machine, and through the GX Simulator6-C software for process simulation. On this basis, the system debugging, installation and the problems in the running process, carries on the analysis,