ug子类型（UG subtype）.docVIP

ug子类型（UG subtype） Type = Mill_Contour Subtype Processing mode describe CAVITY_MILL cavity mill The basic cavity milling operations are used to remove a certain amount of material defined by blanks or IPW and components, with many plane cutting modes. Cavity milling is often used in rough machining. ZLEVEL_FOLLOW_CAVITY cavity mill Cutting internal shape with the following workpiece cutting mode. ZLEVEL_FOLLOW_CORE cavity mill External cutting of shapes using the following workpiece cutting mode. CORNER_ROUGH cavity mill The remaining material in the cutting corner can not be removed because of the relationship between the diameter of the previous tool and the corner radius. ZLEVEL_PROFILE Z grade milling The basic Z level milling is used for contour milling of parts or cutting areas in plane cutting mode. ZLEVEL_PROFILE_STEEP Z grade milling Same as ZLEVEL_PROFILE, but only cutting steep areas. Often used with the CONTOUR_AREA_NON_STEEP to control the residual peaks in the finish machining area. ZLEVEL_CORNER Z grade milling A corner area that cannot be reached due to the diameter and corner radius of a tool before finishing. FIXED_CONTOUR Curved contour milling The basic fixed axis surface profile milling operations are used for various driving methods, inclusion and cutting mode contour milling parts or cutting areas. The tool shaft is +ZM. CONTOUR_AREA Curved contour milling A regional milling drive used to cut the selected face or cutting area in various cutting modes. Often used in semi finishing and finishing. CONTOUR_AREA_NON_STEEP Curved contour milling Same as CONTOUR_AREA, but only cutting non steep area. Often used with the ZLEVEL_PROFILE_STEEP to control the residual peaks in the finish machining area. CONTOUR_AREA_DIR_STEEP Curved contour milling The zone milling drive is based on the cutting direction, only cutting the non steep area. Use with CONTOUR_ZIGZAG or CONTOUR_AREA in order to reduce residual peaks by cross forward reciprocating cutting. CONTO