EQ操作手册（EQ operation manual）.docVIP

EQ操作手册（EQ operation manual） EQ operation manual EQ is the abbreviation of equalizer. Each recording engineer should be master of EQ, which controls the tone by controlling the gain or attenuation of certain bands of sound. Hussein: EQ can be used for noise reduction technology. EQ generally has three parameters: one is F (requency), through the control of it, to make sure that you increase or decrease the frequency; two is G (AIN), through the control of it, in order to achieve the currently selected band promotion or decay; three is Q (uantize) by controlling on it, you need to select the gain or attenuation band width. Its important to note that the smaller the Q value you set, the wider the frequency bands youre dealing with, and the narrower the frequency youre dealing with, the more you set the Q value. There are several common equalizers, one is the simplest, fixed frequency point, fixed Q value of the three segment equalizer. This equalizer is often seen on analog mixers and home amplifiers. Mark LOW, MID, and HIGH respectively to represent the frequency bands they are processing. Most of this equalizer is low-end products, can only be a simple upgrade, not so professional. There is also a fixed Q value, fixed frequency points of the multi section equalizer. This equalizer is often used in field reinforcement. Sound field used to compensate the scene. Probably from the 20 to the 40 paragraph or so. Often used in the recording of the value of the equalizer, a common 3 or 4 paragraph. The equalizer does not have any parameters that are pre-set and needs to be adjusted. First, the use of balanced noise reduction We all want our music, enough quiet and sweet, but due to unforeseen reasons, to make the recording audio noise, many recording engineers told me that if there is noise, then you first solve the noise problem, then work, but often the noise problem, and not everyone can be solved smoothly, such as environmental noise, noise and so on. The use of balance