To install the TR in Windows Vista “” ….docVIP

To install the TR30 in Windows Vista “7” 32 64 bit ALL VERSIONS. Section 1 Uninstalling Device If the TR30 has been connected previously then you need to uninstall it from your system, if the TR30 has NOT been connected you may skip this part move on to the Driver download and installation section below. To Uninstall the TR30, CONNECT THE TR30 (TRXX Device) TO YOUR PC, open your control panel, locate “Device Manager” Click on the Start button and then choose Control Panel. Click on the System and Security link. Note: If youre viewing the Large icons or Small icons view of Control Panel, you wont see this link. Simply click on Device Manager and then proceed to Step 4. In the System and Security window, click on the Device Manager link located under the System heading. You can now use Device Manager to update device drivers, view the system resources that a hardware device is using, etc. Look in the Device manager window for TRXX Device it will probably have either a cross or exclamation mark next to it. Note: The supplied image does not have a cross or exclamation mark because it was taken from a computer where the TR30 driver is correctly installed 2. Uninstall the driver for the TR30 (TRXX Device) Device Manager in Vista 32 Bit, other versions may look different Right click on TRXX Serial Port Click on Uninstall Look for TRXX Device in the Device Manager window above, RIGHT CLICK ON IT You will see a menu appear, look for “Properties” An alternative way to uninstall the driver is as follows, which way you do it depends on your version of Windows. Left click on Properties Look for the tab at the top of the device properties window for Driver Click on the Driver tab Near the bottom of the device properties window you will see the Uninstall Driver Click on it to uninstall the driver DISCONNECT THE TR30 (TRXX Device) AT THIS POINT Proceed to section 2 Section 2 Downloading Installing the driver file Download the driver file from our website /tds2/html/supportdl.