SMART Infusion Pump Administration of Intravenous Therapy Medications[静脉注射治疗和药物治疗的SMART输液泵管理](-40).ppt

Standby Icon Standby is a feature that enables the clinician to put the infusion in a “sleep mode”. It allows the clinician to suspend the infusion without losing the current settings or patient information. When the pump is in the Standby mode, the pump is powered on and the alarms are disabled. Examples for using the Standby mode: Pre-program pump settings prior to admission Bed bath/shower, patient transfer or repositioning Saline lock between medication delivery Patient leaving unit/hospital on a pass MRI (pump cannot go into room) To Activate Standby: From any infuser screen, locate and press Standby. Select the channel to be placed in Standby. * Patient Transfer Upon patient transfer to a different unit, the receiving RHCP must: reprogram the pump with the appropriate CCA. verify physician’s IV orders as soon as possible. At the beginning of each shift, the RHCP must verify that: the infusion against pump settings. the appropriate drug library is being used. Two ways to reprogram infusion pumps: clear settings from previous CCA and reprogram infusions under current CCA, or change settings from previous CCA to multi-CCA * Patient Transfer – Multi CCA Press CCA icon at top of screen. Press current CCA Field (e.g. ICU) and select your desired CCA. Press Yes when Change CCA? screen appears. Press OK when Multiple CCAs screen appears. Press Done. Important Note: All previous infusions will continue to run under initial CCA until VTBI is completed OR program is cleared. Your general CCA label will say Multiple CCA. When the infusion is completed, silence the alarm and stop the infusion. Press desired program tabs (e.g. Basic) to enter more volume. Press OK when Program is being CLEARED screen appears. Pump will automatically switch to new CCA. Channel will now operate under the new CCA drug library. * Locking the Keypad * Steps to lock the keypad: Press the Lock button to display