常用软件介绍及安装--viewdraw.ppt

Installation 1、 Innoveda eProduct Designer 2.0 and the use of viewdraw and ViewGen 2、Hspui U-2003.09(hspice) 3 、EditPlus Set up a new circuit Generate the symbol the circuit The use of the software ViewGen Open the newly-built symbol Simulation In Hspice * Introduction To Normal Use Software zheng-ru-fu 1、Innoveda eProduct Designer 2.0------ Viewdraw/ViewGen 2、 Hspui (Hspice) 3 、EditPlus Installation 1、 Innoveda eProduct Designer 2.0 and the use of viewdraw and ViewGen 2、Hspui U-2005.09(hspice) 3 、EditPlus Innoveda eProduct Designer Installation Put the .ISO file epd2.0 in the virtual CD-driver or Unzip and click setup： then click Next Change your installation name if you like ,and then Next Change the destination address then《Next》 again then《Next》 again 选择： Design Exchange Analog Simulation Then installing After it completed ,choosing to configure EPD. thenfinish Choose not to install the high speed design tools for its uselessness Configure the license Choose Node-locked and then next Enter the license from the former address: D:\ePD\License.data Finished the installation Set up the environment parameter The first opening Build a new project with the project wizard and thennext Carefully arrange the project Directory Adding basicmodel Find the needed software Installation 1、 Innoveda eProduct Designer 2.0 and the use of viewdraw and ViewGen 2、Hspui U-2005.09(hspice) 3 、EditPlus Hspice Installation The installation steps are just next from the beginning of knocking on the setup file Until you meet : The hspice should also initialize the environment parameter just the same as Innoveda eProduct Designer 2.0.But they are conflicted with each other. hspice The solution is as follow: Copy the contents of license.dat of Hspice to license.dat of ePD. Or: use “;” between different License.dat Installation 1、