毕业设计（论文）-遥控器后盖注塑模具设（全套图纸）.doc

PAGE I摘 要本论文以遥控器后盖的注塑模具设计为主要内容，详细介绍了注塑模具设计的一般流程，其中的设计内容有零件的工艺性编制：塑件的工艺性分析、塑件的体积和质量计算及注射机参数的确定；结构设计：分型面选择、型腔数确定、型腔的排列方式、浇口设计、侧向分型抽芯机构设计、推出及复位机构方式确定；型芯、型腔尺寸计算；模具加热和冷却系统计算；模具闭合高度确定；注射机有关参数的校核；如此设计出的结构可确保模具工作运用可靠。最后对模具结构与注射机的匹配进行了校核。并用AutoCad绘制了一套模具装配图和零件图。关键词：遥控器后盖；侧抽芯；工艺分析全套图纸加153893706 PAGE III PAGE IIIABSTRACTIn this paper with the remote control back cover injection mold design as the main content, the general flow of injection mould design was introduced in detail, including the design of the manufacturability of the parts content: the volume of the manufacturability analysis of plastic parts, plastic parts and confirmed the parameters calculation and injection machine quality; Structure design, selection of parting surface, cavity number, cavity arrangement, the gate design, side parting core-pulling mechanism design, launch and reset institutions to determine; Core and cavity size calculation; Calculating mould heating and cooling system; Die closed height determine; Injection machine related parameters of checking; Such a structure are designed, which can ensure the mold work using reliable. The final match of the mould structure and injection machine for checking. Using AutoCad draw a set of mold assembly drawing and part drawing.Keywords: remote control back cover; Side core-pulling. Technology analysis PAGE IV PAGE IV PAGE V PAGE V目录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc418079129 摘 要 PAGEREF _Toc418079129 \h I HYPERLINK \l _Toc418079130 ABSTRACT PAGEREF _Toc418079131 \h III HYPERLINK \l _Toc418079132 前言 PAGEREF _Toc418079132 \h 1 HYPERLINK \l _Toc418079133 第一章 零件工艺分析 PAGEREF _Toc418079133 \h 5 HYPERLINK \l _Toc418079134 1.2塑件的结构、表面质量和尺寸精度分析 PAGEREF _Toc418079134 \h 7 HYPERLINK \l _Toc418079135 1.2.1结构分析 PAGEREF _Toc418079135 \h 7 HYPERLINK \l _Toc418079136 1.2.2表面质量分析 PAGEREF _Toc418079136 \h 7 HYPERLINK \l _Toc418079137 1.2.3表面质量分析 PAGEREF _Toc418079137 \h 8 HYPERLINK \l _Toc418079138 第二章 注塑机的确定 PAGEREF _Toc418079138 \h 9 HYPERLINK \l _Toc4180