毕业论文---基于单片机的霓虹灯控制器的设计-毕业论文.doc

第 PAGE \* MERGEFORMAT 32页 共47页 基于单片机的霓虹灯控制器的设计 摘 要 本设计采用AT89C52单片机实现对霓虹灯的控制。系统由红外遥控模块、单片机控制模块、显示模块、语音模块四部分组成。红外遥控模块分红外发射部分和红外接收部分，通过单片机译码后，取出红外发射按钮的地址，从而实现红外遥控器对霓虹灯显示图案的远距离控制。红外接收管也只占用一个IO口。显示部分为16×16的点阵模块，通过单片机控制显示不同的图案以及想要的文字，并让字能够移动、暂停，以及从当前文字切换其它文字。语音模块采用的语音芯片是ISD1730，可以录制想要的语音，通过录音可以对设计进行介绍。语音的播放支持暂停、下一首、调节音量和复位。由于单片机的IO口不够用，本设计采用74HC154对其扩充，将四线扩充到十六线。该系统具有电路结构简单、易操作、成本低等优点，具有较强的实用价值。 关键词：单片机；红外遥控；点阵；译码器；霓虹灯 The Design of the Neon Lights controller Based on SCM Abstract This design uses the AT89C52 single chip microcomputer to control the neon lights. The?system?is?composed?by the infrared remote control module, the single-chip microcomputer control module, the display module and the speech module. Infrared remote control module is divided into the infrared transmitter and infrared receiver parts. After decoding through the single chip microcomputer, the infrared emission button address can be taken out in order to realize the remote control of infrared neon lights display. The infrared receiving tube only takes up one IO port. The display part uses the dot matrix module with 16 plus 16, through the single-chip control, it can display different patterns and the text, and make the word to move, pause, and switch from the current text to the other. The voice module uses voice chip ISD1730, which can record the desired voice, which can be played to introduce the design. It is support for pause, next, adjust the volume and reset of the voice playback. Due to the IO port of the microcontroller is not enough, this design uses a 74HC154 to expand the IO port, which is expanding the four-line to 16-line. The system has a strong practical value because of its advantages of simple circuit structure, easy operation and low cost. Key words: Single Chip; Infrared Remote Control; HYPERLINK app:ds:dot \t Dot HYPERLINK app:ds:matrix \t Matrix; Decoder; Neon Lights 目 录 论文总页数：47页 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc327437586 1 引言 PAGEREF _Toc327437586 \h 4 HYPER