毕业设计论文 外文文献翻译 运算放大器理想及实际模型.doc

无 锡 职 业 技 术 学 院 毕业设计说明书（英文翻译） PAGE PAGE 9 无 锡 职 业 技 术 学 院 毕业设计说明书（英文翻译） PAGE 1 Operational Amplifiers Ideal and Practical Models The concept of the operational amplifier(usually referred to as an op amp ) originated at the beginning of the Second World War with the use of vacuum tubes in dc amplifier designs developed by the George A. Philbrick Co. [some of the early history of operational amplifiers is found in Williams, 1991]. The op amp was the basic building block for early electronic servomechanisms, for synthesizers, and in particular for analog computers used to solve differential equations. With the advent of the first monolithic integrated-circuit (IC) op amp in 1965 (the ?A709, designed by the late Bob Widlar, then with Fairchild Semiconductor), the availability of op amps was no longer a factor, while within a few years the cost of these devices (which had been as high as $200 each) rapidly plummeted to close to that of individual discrete transistors. Although the digital computer has now largely supplanted the analog computer in mathematically intensive applications, the use of inexpensive operational amplifiers in instrumentation applications, in pulse shaping, in filtering, and in signal processing applications in general has continued to grow. There are currently many commercial manufacturers whose main products are high-quality op amps. This competitiveness has ensured a marketplace featuring a wide range of relatively inexpensive devices suitable for use by electronic engineers, physicists, chemists, biologists, and almost any discipline that requires obtaining quantitative analog data from instrumented experiments. Most operational amplifier circuits can be analyzed, at least for first-order calculations, by considering the op amp to be an “ideal” device. For more quantitative information, however, and particularly when frequency response and dc offsets are important, one must refer to a more “practical” model that includes the