MS200-41硫化橡胶.doc

SCOPE OF APPLICATION ?? ?? ENGINEERING STANDARD SHT/SHTS ALL 1/58 ESTABLISHED MATERIAL SPECIFICATION SPEC No. POLYMERIC MATERIALS RESEARCH TEAM MS 200-41 TITLE: TEST STANDARD – SOFT VULCANIZED RUBBER CONTENTS SCOPE TEST ITEMS GENERAL TEST CONDITIONS TESTING 4.1 HARDNESS TEST 4.2 TENSILE TEST 4.3 AGING TEST 4.4 COMPRESSION SET TEST 4.5 OIL RESISTANCE TEST 4.6 TEAR RESISTANCE TEST 4.7 OZONE RESISTANCE TEST 4.8 COLD SHORTNESS TEST 4.9 BEND TEST 4.10 IMPACT RESISIENCE TEST 4.11 LOW ELONGATION STRESS TEST 4.12 METAL ADHESION TEST 4.13 PEEL STRENGTH TEST 4.14 PERMANENT EXTENSION SET TEST OTHERS a EMS40706 RETYPING ALL 11.23.04 H.O.KIM 870708 ISSUE OF ENGLISH SPECIFICATION ALL JUL.08.87 SYM EO NO DESCRIPTION OF CHANGE REV.PAGE REV.DATE REV.BY ESTABLISHMENT 1985. 02. 21 REFERENCE PREPARED BY SIGNED H.O.KIM CHECKED BY SIGNED B.K.MIN APPROVED BY SIGNED T.W.HWANG ORIGINAL FILED AT IPIS (ES/MS MANAGEMENT SYSTEM) 11-18-04 11-18-04 11-22-04 1F-SG-00016 HYUNDAI?KIA MOTOR Scope This specification applies to the test standard required to specify the quality of soft vulcanized rubber. Test Items The test items required in this specificaton shall be listed as follows : Hardness Test Tensile Test Aging Test Compression Set Test Oil Resistance Test Tear Resistance Test Ozone Resistance Test Cold Shortness Test Bend Test Impact Resilience Test Low Elongation Stress Test Metal Adhesion Test Peel Strength Test Permanent Extension Set Test General Test Conditions 3.1 Normal State of Laboratory : The normal state of laboratory shall be as a rule at 20 ℃ and the test temperature shall be reported. 3.2 Normal State of Test Specimens : Test specimens shall be, as a rule, allowed to stand at least 24 hr after vulcanization and 1 hr or more in the normal state before test. 3.3 Rounding of Test Result