模具设计dfm.pptVIP

擦穿位置分析 Shut off position Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 此面插穿角不够，需修到3度 产品出模分析 Product Draft analysis Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG Draft analysis Draft OK 产品料厚分析 Product Thickness analysis Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 产品胶料厚度均匀 产品光洁度标准 NO Texture 请提供光洁度标准 Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 1、版本号我司做镶针，相关的字体我司默认为晒字，深0.2MM，凸字。 日期镶件（年月一起） Engraving ( Others ) Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG 模具排位 Mould overall dimensions Mold overall layout EJ SIDE PLAN VIEW 550 650 模胚已超报价（4045），请客人确认是否合适啤机，同时，市场考虑是否增加报价 * 备注Remark： 烦请贵司在我司提供的开模方案上每页做明确回复（同意或不同意），如未作明确回复的部分，我司将视为默认我司方案，我司将按此方案进行后续工作。 Please reply against our PPT in each page (OK or Nok), if there is no comment in any page of the PPT ,we will consider it as “OK” and we will implement the proposal in the PPT. THANK YOU! * * * * * * * * * * * * * * * * * FS0000F DFM Report DFM Engineer：LIMIN Approved: Date：2014/02/26 DFM – Design For Manufacture Project name: Mould No. FS0000E Customer Name UKAG Customer mould No. 请客人提供 Part No. Screen Side Frame Cavities 1+1 Material PC/ABS BAYER T65XF Size for 1 part 182.7X126.9X35 Inch/mm mm 产品信息 Product Information 开 模 客 供 资料 information to be provided by customer 序号 资料名称Name 内 容 Description 收到日期 Received date 备注 remarks 1 胶 料 (resin) PC/ABS BAYER T65XF 2014.02.25 2 缩 水 率 (hrinkage) 请客人提供 我们选定为0.005，请客人确认或提供 3 啤机吨位 (Press tonnage) 请客人提供啤机的相关信息 4 设计标准customer tooling standard 请客人提供 5 胶料特性 resin date sheet 请客人提供 开模时需要收到的客供资料 上下模分析 CAV/COR Customer comment. (please give your approval and comments) Date Approval by: Remark OK or NG cavity side core side 进浇口建议 Gate Advice（方案一） 冷流道，两点潜水入胶 17