注塑模的参数控制型腔布.doc

PAGE PAGE 15 嘉兴学院南湖学院外文文献翻译译文 题　　目：　　 拉钩的冷冲模设计 系 别：　 机电工程系 专 业： 机械设计制造及其自动化 班 级：　　机械N061　 学 号：　 2006456790601　 学生姓名： 潘晓慧 外文原文 A Parametric-Controlled Cavity Layout Design System for a Plastic Injection Mould M. L. H. Low and K. S. Lee Department of Mechanical Engineering, National University of Singapore Today, the time-to-market for plastic products is becoming shorter, thus the lead time available for making the injection mould is decreasing. There is potential for timesaving in the mould design stage because a design process that is repeatable for every mould design can be standardised. This paper presents a methodology for designing the cavity layout for plastic injection moulds by controlling the geometrical parameters using a standardisation template. The standardization template for the cavity layout design consists of the configurations for the possible layouts. Each configuration of the layout design has its own layout design table of all the geometrical parameters. This standardisation template is pre-defined at the layout design level of the mould assembly design. This ensures that the required configuration can be loaded into the mould assembly design very quickly, without the need to redesign the layout. This makes it useful in technical discussions between the product designers and mould designers prior to the manufacture of the mould. Changes can be made to the 3D cavity layout design immediately during the discussions, thus saving time and avoiding miscommunication. This standardisation template for the cavity layout design can be customised easily for each mould making company to their own standards. Keywords: Cavity layout design; Geometrical parameters; Mould assembly; Plastic injection mould design; Standardisation template 1. Introduction Plastic injection moulding is a common method for the mass production of plastic parts with good tolerances. There are two main items that are requi