推挽式功率放大电路的设计说明书.doc

word格式可编辑 专业资料整理 第 一 部 分 课 程 设 计 专业资料整理 摘 要 桥式推挽功率放大器是一种在较低的电源电压下能得到较大输出功率的功放，它由前置放大电路、BTL功率放大电路、电源电路三部分所构成。前置放大电路采用了集成运放NE5532将小信号电压放大，使其能够驱动功率放大器；功率放大电路由倒相电路和BTL电路两部分组成，前者负责为后者转换两个大小相等、方向相反的激励信号，后者则是在信号不失真的前提下，尽可能地放大电流，从而提高输出功率；电源电路通过降压、整流、滤波、稳压产生±12V直流电压。运用Protel软件对所设计的电路图进行建库、绘图、制板；再借助Multisim仿真软件对各个单元电路进行了性能与功能仿真，通过仿真分析验证了设计的正确性，整体电路也基本达到了设计的预期目的。 关键词：推挽功放；集成运放；前置放大；倒相 专业资料整理 Abstract The push-pull circuit occupies an important position in the amplifier circuit and switching power supply areas. Bridge push-pull amplifier circuit is constituted by three parts of the power supply circuit, the preamplifier circuit, BTL power amplifier circuit. The preamplifier circuit uses the integrated operational amplifier NE5532 small signal voltage amplification, so that the power amplifier input sensitivity to match. The power amplifier circuit consists of two parts of the inverting circuit and BTL circuit. The former is responsible for the conversion for the latter two of equal size, in the opposite direction of the excitation signal. The latter is the signal undistorted under the premise, as far as possible to enlarge the current, increasing the output power. ± 12V DC voltage power circuit through the buck, rectifier, filter and regulator.With of Multisim simulation software on each unit circuit performance and functional simulation. Verify the correctness of the design through simulation analysis, the results are to achieve the intended purpose of the design. Then use Protel software for building a database, drawing and board schematic design. Keywords：Push-pull amplifier, Integrated operational amplifier, Preamplifier , Inverting word格式可编辑 专业资料整理 目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc328732076 摘 要 PAGEREF _Toc328732076 \h I HYPERLINK \l _Toc32873207