整理的IBM 5709卡更换电池.doc

IBM?5709卡更换电池 一：用smit pxdam 快捷键进入PCI-X SCSI Disk Array Manager 二：查看电池状态： 1.Select Diagnostics and Recovery Options. 2.Select Controller Rechargeable Battery Maintenance. 3.Select Display Controller Rechargeable Battery Information. 电池状态：有4种状态， battery type No battery warning/error No warning or error condition currently exists. Warning condition A warning condition currently exists and an error has been logged. Error condition An error condition currently exists and an error has been logged. Unknown Information is not available to determine whether a warning or error condition currently exists. 强迫电池错误，如下： 1.smit pxdam 2. Select Diagnostics and Recovery Options. 3. Select Controller Rechargeable Battery Maintenance. 4. Select Force Controller Rechargeable Battery Error. 5. Select your PCI-X SCSI RAID Controller whose battery you want to replace. 6. Press Enter. 7. Replace the Cache Battery Pack as described in “Replacing the Rechargeable Cache Battery Pack 三：更换电池 注意事项：?? 在换电池之前，在连接新的电池之前，电池一定是分离在至少60秒(最好为2分钟)，认为电池被替换了  下面是网上资料： 第一：强行控制电池错误，如下：1.Select??Diagnostics??and??Recovery??Options. 2.Select??Controller??Rechargeable??Battery??Maintenance. 3.Select??Display??Controller??Rechargeable??Battery??Information. 4.选择电池您想要替换的PCI-X SCSI RAID控制器5.Enter 第二：换好后需要启动cache到这个菜单--Diagnostics and Recovery Options--Select Controller Rechargeable Battery Maintenance--Select Start Adapter Cache. 第三：注意事项：?? 在换电池之前，在连接新的电池之前，电池一定是分离在至少60秒(最好为2分钟)，认为电池被替换了 备机换电池步骤：1、执行上面步骤，将电池强行弄坏2、关机先关备机双机，应用，数据库3、拆机箱，换备机电池4、换完电池后，装机箱，并加电5、开备机的数据库，应用，双机6、观察一段时间后，确认没有报警或错误日志后，再换主机电池 主机换电池步骤：1、先把应用切换到备机2、执行上面步骤，将电池强行弄坏3、关主机的双机，应用，数据库4、拆机箱，换主机电池5、换完电池后，装机箱，并加电6、开主机的数据库，应用，双机7、观察一段时间后，确认没有报警或错误日志后8、再把应用切换到主机 备机关机：??????????????????????????????????????????????????备机开机： 1、关smitty clstop??????????????????????????????????????????1、启动数据库：su – oracle2、关应用??????????????????????????????????????????????????????????????????????oraclesqlplus “/assysdba” 3、关数据库：su – o